Home › ENGINE ยท 2TR-FE › ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)
(Click here)


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
(Click here)


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)


    C114267E01
  1. Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the set bolts, and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.



4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.



5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


    A102137E01
  1. Fix the crankshaft with SST.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A109815E02
  1. Remove the 10 bolts and flywheel.



6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


    A102137E01
  1. Fix the crankshaft with SST.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A102156E01
  1. Remove the 10 bolts, spacer RR, drive plate and spacer FR.



7. REMOVE ENGINE REAR OIL SEAL


    A102142E02
  1. Using a knife, cut through the oil seal lip.

  1. Using a screwdriver with its tip taped, pry out the oil seal.

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.