Home › ENGINE ยท 2KD-FTV › ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)
(Click here)


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
(Click here)


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)


    C114267E01
  1. Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the set bolts, and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.



4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.



5. REMOVE FLYWHEEL SUB-ASSEMBLY


    A072851E01
  1. Fix the crankshaft with SST.

    SST
    09213-58013  
    09330-00021  



    A102803E01
  1. For manual transmission.

    1. Remove the 8 bolts and flywheel.

  1. For automatic transmission.

    1. Remove the 8 bolts, and remove the drive plate spacer rear, drive plate and flywheel.



6. REMOVE REAR END PLATE
  1. Remove the bolt and rear end plate.



7. REMOVE ENGINE REAR OIL SEAL RETAINER


    A038736
  1. Remove the 7 bolts and engine rear oil seal retainer.



8. REMOVE ENGINE REAR OIL SEAL


    A077206E01
  1. Remove the oil seal with a slotted screwdriver in the manner shown in the illustration.

    HINT:
    Put a protection material around its sharp end of the screwdriver to protect the oil seal retainer.

  1. Remove oil seal packing (FIPG) from the engine rear oil seal retainer.