EXHAUST PIPE (for Long Wheelbase) > REMOVAL |
| 1. REMOVE EXHAUST PIPE ASSEMBLY FRONT |
w/ Secondary air infection system:
Disconnect the fuel ratio sensor connector.
Remove the fuel ratio sensor. (Click here)
For unleaded gasoline engine:
Disconnect the oxygen sensor connector.
Remove the oxygen sensor. (Click here)
Remove the 4 bolts, 2 nuts, and 2 compression springs.
Remove the 2 gaskets from the exhaust pipe assembly front.
Disconnect the exhaust pipe support, and remove the exhaust pipe assembly front.
| 2. REMOVE EXHAUST PIPE ASSEMBLY TAIL |
Disconnect the exhaust pipe supports, and remove the exhaust pipe assembly tail.