Home › ENGINE ยท 2KD-FTV › CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. DISCONNECT NEGATIVE BATTERY CABLE


2. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)


3. REMOVE FRONT DOOR SCUFF PLATE RH


4. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

HINT:
Perform the same procedure as above on the opposite side. (Click here)



5. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

HINT:
Perform the same procedure as above on the opposite side. (Click here)



6. REMOVE ENGINE SERVICE HOLE SUB COVER ASSEMBLY
  1. Roll up the carpet, and remove the engine service hole sub cover assembly.



7. REMOVE FENDER APRON MUDGUARD SEAL RH


8. REMOVE FAN AND GENERATOR V BELT


    A102808E03
  1. Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.



9. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (w/ Air Conditioning)
  1. Disconnect the connector.



    E104245
  1. Remove the 4 bolts and compressor and magnetic clutch.



10. REMOVE AIR TUBE ASSEMBLY
  1. Remove the 2 clamps, 2 bolts and air tube assembly.



11. REMOVE AIR CLEANER HOSE ASSEMBLY
  1. Remove the bolt and air cleaner hose assembly.



12. REMOVE VENTILATION PIPE


    A115758
  1. Loosen the clip, and disconnect the ventilation hose.

  1. Remove the bolt and the ventilation pipe.



13. REMOVE COMPRESSOR OUTLET ELBOW


    A113753
  1. Remove the 2 bolts and 2 clamps, then remove the compressor outlet elbow.



14. REMOVE IDLE NO.2 PULLEY ASSEMBLY (w/ Air Conditioning)


    A102711E01
  1. Remove the bolt and washer, then remove the idle No.2 pulley assembly.



15. REMOVE GENERATOR BRACKET


    A102712E01
  1. Remove the 2 bolts, then remove the generator bracket.



16. REMOVE GENERATOR ASSEMBLY


    A113682E01
  1. Disconnect the generator connector.

  1. Remove the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Remove the bolt and generator assembly.