Home › ENGINE ยท 2KD-FTV › FUEL › FUEL TANK

FUEL TANK > INSTALLATION

for Preparation Click here



1. INSTALL FUEL SENDER GAUGE ASSEMBLY
  1. Install the fuel hose grommet to the fuel tank assembly.

  1. Install a new fuel suction tube set gasket, fuel pump gauge retainer and fuel sender gauge assembly with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 32 in.*lbf }

  1. Install the fuel tank wire, fuel evaporation No.1 tube sub-assembly, fuel tank main tube sub-assembly and fuel tank return tube sub-assembly to the fuel sender gauge assembly.



2. INSTALL FUEL TANK ASSEMBLY


    A102475J06
  1. Using the transmission jack, install the 2 fuel tank band sub-assemblies and fuel tank assembly with the 6 bolts.

    Torque:
    38 N*m{ 398 kgf*cm , 32 ft.*lbf }

  1. Connect the parking break cable No.3 with the blot.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }



3. CONNECT FUEL HOSE NO.3


    A102472J09
  1. Connect the fuel hose No.3, and tighten the clamp bolt.



4. CONNECT FUEL TANK BREATHER TUBE


    A102474J06
  1. Connect the fuel tank breather tube and clip.



5. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    A102470J04
  1. Connect the fuel tank main tube sub-assembly with the clip.



6. CONNECT FUEL TANK RETURN TUBE SUB-ASSEMBLY


    A102468J06
  1. Connect the fuel return tube sub-assembly. (Click here)



7. CONNECT FUEL TANK WIRE


    A102471E03
  1. Connect the fuel tank wire.



8. INSTALL INSTALL PROPELLER SHAFT ASSEMBLY

HINT:
  1. Propeller shaft assembly for Super Long Wheelbase (Click here)
  2. Propeller shaft assembly for Long Wheelbase (Click here)



9. CHECK FOR FUEL LEAKS
  1. PERFORM ACTIVE TEST

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / ECD / Active Test.

    5. Perform the Active Test.

      Intelligent Tester Display
      Test Details
      Control Range
      Diagnostic Notes
      Test the Fuel Leak
      Pressurizes common rail internal fuel pressure, and checks for fuel leaks
      Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when ON is selected
      2. Above conditions preserved while test is ON