Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM

ECD SYSTEM > CHECK FOR INTERMITTENT PROBLEMS

for Preparation Click here


HINT:
Intelligent tester:
Inspect the vehicle's ECM using check mode. Intermittent problems are easier to detect when the ECM is in check mode with the intelligent tester. In check mode, the ECM uses 1 trip detection logic, which has a higher sensitivity to malfunctions than normal mode (default), which uses 2 trip detection logic.

  1. Clear the DTCs (Click here).
  2. Change the ECM from normal mode to check mode using the intelligent tester (Click here).
  3. Perform a simulation test (Click here).
  4. Check the connector and terminal (Click here).
  5. Wiggle the harness and the connector (Click here).