DTC P0093/78 Fuel System Leak Detected - Large Leak |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0093/78 | Fuel leaks in high-pressure areas (1 trip detection logic) |
|
| Engine Speed | Fuel Pressure |
| Idling | Approximately 25 to 35 MPa |
| 3,000 rpm (No engine load) | Approximately 35 to 55 MPa |
| Required sensors | Fuel Pressure sensor |
| Frequency of operation | Continuous |
| Duration | 1 second |
| MIL operation | 1 driving cycle |
| Item | Specification | Specification |
| Minimum | Maximum | |
| Engine speed | 600 rpm | - |
| The monitor will not run if the fuel pressure sensor or suction control valve circuit is malfunctioning. | ||
| Threshold |
| Large drop in the internal fuel pressure when injecting fuel |
| 1.CHECK OTHER DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: Powertrain / ECD / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0093/78 | A |
| P0093/78 and "P0200/97 and/or 1229/78" | B |
|
| ||||
| A | |
| 2.CHECK FUEL LEAKAGE (IN HIGH-PRESSURE FUEL PARTS AND AREAS) |
Visually check the supply pump, each injector and fuel line located between the supply pump and common rail for fuel leaks or fuel pressure leaks. Also, perform the same on the fuel line between the common rail and each injector (Click here).
|
| ||||
| OK | |
| 3.READ VALUE OF COMPENSATORY INJECTION VOLUME |
Connect the intelligent tester to the DLC3.
Start the engine and turn the intelligent tester ON.
Enter the following menus: Powertrain / ECD / Data List / Injection Feedback Val #1, #2, #3 and #4.
Read the values.
|
| ||||
| OK | |
| 4.PERFORM ACTIVE TEST BY INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Start the engine and turn the intelligent tester ON.
Enter the following menus: Powertrain / ECD / Active Test / Test the Fuel Leak.
Check for fuel leaks in the high-ressure areas.
| NEXT | ||
| ||
| 1.CHECK DTC OUTPUT |
Turn the ignition switch ON.
Read DTCs.
| Display (DTC output) | Proceed to |
| P0093/78 only | A |
| P0093/78 and P0200/97 | B |
|
| ||||
| A | |
| 2.CHECK FUEL LEAKAGE |
Visually check the supply pump, each injector and fuel line located between the supply pump and common rail for fuel leaks or fuel pressure leaks. Also, perform the same on the fuel line between the common rail and each injector (Click here).
|
| ||||
| OK | ||
| ||