STEERING PAD > INSTALLATION |
| 1. INSTALL STEERING PAD |
Support the steering pad with one hand.
![]() |
Connect the connector to the steering pad.
Connect the horn connector.
Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
![]() |
Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.
| 2. INSTALL STEERING WHEEL COVER LOWER NO.3 |
Install the steering wheel cover lower No.3.
| 3. INSTALL STEERING WHEEL COVER LOWER NO.2 |
Install the steering wheel cover lower No.2.
| 4. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL |
| 5. INSPECT STEERING PAD |
![]() |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Make sure that the horn sounds.
| 6. INSPECT SUPPLEMENTAL RESTRAINT SYSTEM WARNING LIGHT |
| 7. PERFORM INITIALIZATION |