Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL INSTRUMENT PANEL WIRE NO.3


    C102034
  1. Connect the connector to the front passenger airbag assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
  1. Engage the clamps and claws, and install the front passenger airbag assembly.



    C106066
  1. Install the instrument panel passenger airbag with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



    C106065E02
  1. Connect the airbag connector.

  1. Install the airbag connector to the reinforcement.



3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


4. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL


5. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY


    C113663
  1. With the front passenger airbag installed on the vehicle, perform a visual check. If there are any defects mentioned below, replace the instrument panel with a new one:

    1. Cuts, minute cracks or marked discoloration on the instrument panel around the front passenger airbag.



6. INSPECT SUPPLEMENTAL RESTRAINT SYSTEM WARNING LIGHT
(Click here)


7. PERFORM INITIALIZATION
Some system need initialization when reconnecting battery cable. (Click here)