BRAKE PEDAL > ADJUSTMENT |
| 1. INSPECT BRAKE PEDAL HEIGHT |
![]() |
Check brake pedal height.
| 2. ADJUST BRAKE PEDAL HEIGHT |
Disconnect the stop light switch connector.
Turn the stop light switch assembly counter-clockwise and remove it.
Remove the brake booster (Click here).
Loosen the push rod lock nut.
Adjust the pedal height by turning the pedal push rod clevis.
Tighten the push rod lock nut.
Install the brake booster (Click here).
![]() |
Insert the stop light switch into the adjuster until it slightly touches the cushion.
![]() |
Turn the stop light switch assembly clockwise by approximately 90°.
Connect the stop light switch connector.
Check the clearance of the shaft.
| 3. INSPECT BRAKE PEDAL FREE PLAY |
Stop the engine and depress the brake pedal several times until there is no more vacuum left in the booster.
![]() |
Push in the pedal until the beginning of the resistance is felt. Measure the distance as shown in the illustration.
| 4. INSPECT BRAKE PEDAL RESERVE DISTANCE |
Stop the engine and depress the brake pedal several times until there is no more vacuum left in the booster.
Release the parking brake handle.
![]() |
With the engine running, depress the pedal and measure the pedal reserve distance as shown in the illustration.