Home › BRAKE › BRAKE CONTROL › FRONT SPEED SENSOR

FRONT SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SPEED SENSOR FRONT


    C106110
  1. Install the front speed sensor to the steering knuckle with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    Prevent foreign matter from attaching to the sensor tip.



    C106109
  1. Install the bracket to the upper arm with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



    C106108
  1. LH side:

    1. Connect the connector.

    2. Engage the clamp to the body.



    C113672
  1. RH side:

    1. Connect the connector.

    2. Engage the clamp to the bracket.

    3. Install the bracket with the bolt.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



2. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }



3. INSTALL HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY (RH POSITION)


4. INSTALL FRONT DOOR SCUFF PLATE RH (RH POSITION)


5. INSTALL FRONT SEAT ASSEMBLY RH (RH POSITION)


    B107528
  1. Connect the front seat inner belt assembly connector and install the front seat assembly.

  1. Align the front seat assembly adjuster pin with the holes in the body.

  1. Move the front seat assembly to the rearmost position.

    NOTICE:
    Make sure that the front seat assembly is securely locked.

  1. Temporarily tighten the 2 bolts on the front side of the front seat assembly.

  1. Move the front seat assembly fully forward.

    NOTICE:
    Make sure that the front seat assembly is securely locked.

  1. Temporarily tighten the 2 bolts on the rear side of the front seat assembly.

  1. Move the front seat assembly to the rearmost position.

    NOTICE:
    Make sure that the front seat assembly is securely locked.

  1. Fully tighten the 2 bolts on the front side of the front seat assembly in the order of outer and inner side.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

  1. Move the front seat assembly fully forward.

    NOTICE:
    Make sure that the front seat assembly is securely locked.

  1. Fully tighten the 2 bolts on the rear side of the front seat assembly in the order of outer and inner side.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



6. CHECK SPEED SENSOR SIGNAL
(Click here)