Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/ Secondary Air Injection System)

SFI SYSTEM (w/ Secondary Air Injection System) > BASIC INSPECTION

for Preparation Click here


When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential for engine troubleshooting.


1.CHECK BATTERY VOLTAGE

    CAUTION:
    Carry out this check with the engine stopped and ignition switch OFF.

    Result
    Proceed To
    11 V or more
    A
    Below 11 V
    B


B.
CHARGE OR REPLACE BATTERY
A


2.CHECK IF ENGINE CRANKS


    NG.
    PROCEED TO PROBLEM SYMPTOMS TABLE
    OK


    3.CHECK ENGINE STARTS


      NG.
      GO TO STEP 7
      OK


      4.CHECK AIR FILTER
      1. Visually check that the air filter is not contaminated with dirt or oil.



      NG.
      REPLACE AIR FILTER
      OK


      5.CHECK IDLING SPEED
      1. Check idling speed .



      NG.
      PROCEED TO PROBLEM SYMPTOMS TABLE
      OK


      6.CHECK FUEL PRESSURE
      1. Check fuel pressure .



      NG.
      PROCEED TO TROUBLESHOOT
      OK


      7.CHECK FOR SPARKS
      1. Check for sparks (Click here).



      NG.
      PROCEED TO TROUBLESHOOT
      OK

      PROCEED TO PROBLEM SYMPTOMS TABLE