DTC P0016 Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0016 | Deviations in crankshaft and camshaft position sensor signals (2 trip detection logic) |
|
| 1.CHECK VALVE TIMING (CHECK FOR LOOSE AND JUMPED TEETH ON TIMING CHAIN) |
![]() |
Remove the cylinder head cover .
Turn the crankshaft pulley, and align its groove with the timing mark "0" on the timing chain cover.
Check that the point marks on the camshaft timing gears are as shown in the illustration.
If not, turn the crankshaft 1 revolution (360°) and align the marks as shown in the illustration.
Reinstall the cylinder head cover.
|
| ||||
| OK | |
| 2.REPLACE ECM |
| NEXT | |
| 3.CHECK DTC |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Clear DTCs (Click here).
Switch the ECM from normal mode to check mode using the tester (Click here).
Start the engine and warm it up.
Allow the engine to idle for 1 minute or more, and then drive the vehicle for 1 minute or more.
Confirm that no DTC is set using the tester.
| NEXT | ||
| ||