Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Open in CAN Main Bus Line

for Preparation Click here


DESCRIPTION

The CAN main bus line and DLC3 sub bus line may have a disconnection when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is more than 69 Ω.

Symptom
Trouble Area
Resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is more than 69 Ω.
  1. CAN main bus line
  2. ECM
  3. CAN J/C

WIRING DIAGRAM


C107866E01


INSPECTION PROCEDURE

1.CHECK DLC3


    G026206E24
  1. Measure the resistance according to the value(s) in the table below.

    Result:
    Tester Connection
    Condition
    Specified Value
    Result
    H23-6 (CANH) - H23-14 (CANL)
    IG switch OFF
    108 to 132 Ω
    A
    H23-6 (CANH) - H23-14 (CANL)
    IG switch OFF
    132 Ω or higher
    B

    NOTICE:
    When the measured value is 132 Ω or higher and air conditioning control functions (cooling, heating, and dehumidification) do not operate normally, there may be a fault other than a disconnection in the DLC3 sub bus line. For that reason, troubleshooting should be performed again from "HOW TO PROCEED WITH TROUBLESHOOTING (Click here )" after repairing the trouble area.



B
REPAIR OR REPLACE DLC3 SUB BUS LINE OR CONNECTOR (CAN-H, CAN-L)
A


2.INSPECT CAN J/C


    G031933E04
  1. Disconnect the CAN main bus line connector (H4) from the CAN J/C.

    NOTICE:
    1. Before disconnecting the connector, make a note of where it is connected.
    2. Reconnect the connector to its original position.



    G026370E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Between the terminals where the connector (H4) was connected
    Condition
    Specified value
    CANH - CANL
    IG switch OFF
    108 to 132 Ω



NG
REPLACE CAN J/C
OK


3.INSPECT ECM


    C107867E02
  1. Disconnect the connector (B7) from the ECM.



  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    2TR-FE:
    Tester connection
    Condition
    Specified value
    B7-33 (CANH) -
    B7-34 (CANL)
    IG switch OFF
    108 to 132 Ω
    2KD-FTV:
    Tester connection
    Condition
    Specified value
    B7-24 (CANH) -
    B7-23 (CANL)
    IG switch OFF
    108 to 132 Ω


    C101955E02



NG
REPLACE ECM
OK

REPAIR OR REPLACE CAN MAIN BUS LINE OR CONNECTOR (CAN J/C - ECM)