Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here




1.CHECK DTC
  1. Check DTC (See page).

  2. Result:
    U0001/A2 is output.

    HINT:
    1. Applicable only to automatic transmission vehicles with 2KD-FTV engine.
    2. YES: (Click here)



YES.
GO TO THE FLOW CHART FOR "U0001/A2"
NO


2.DIAGNOSE AND CHECK SYMPTOM
  1. Check that the air conditioning control functions (cooling, heating and dehumidification) operate normally.

    Standard:
    The functions operate normally.

    HINT:
    This vehicle uses the CAN communication system for communication between the air conditioning amplifier and ECM. The air conditioning control functions (cooling, heating and dehumidification) stop when communication is impossible.



YES.
CAN COMMUNICATION IS NORMAL
NO


3.CHECK CAN BUS LINE

    HINT:
    CAN bus line (Click here).


NEXT


4.CHECK USING INTELLIGENT TESTER
  1. Select "Communication Bus Check" (Click here).

    Result:

    Go to step
    Result
    A
    "Engine", "ECT (*1)", and "A/C" are displayed.
    B
    "Engine" and "ECT (*1)" are not displayed ("A/C" is displayed)
    C
    "A/C" is not displayed ("Engine" and "ECT (*1)" are displayed).
    D
    "Engine", "ECT (*1)", and "A/C" are not displayed.

    HINT:
    1. *1: Installed on only automatic transmission vehicle with 2KD-FTV engines.
    2. C: "Air Conditioning Amplifier Communication Stop Mode" (Click here)
    3. D: "Open in One Side of CAN Sub Bus Line" (Click here)



B.
REPLACE ECM

C.
GO TO "AIR CONDITIONING AMPLIFIER COMMUNICATION STOP MODE"

D.
GO TO "OPEN IN ONE SIDE OF CAN SUB BUS LINE"
A

GO TO" AIR CONDITIONING SYSTEM"