Home › STEERING › POWER STEERING › VANE PUMP (for 5L-E)

VANE PUMP (for 5L-E) > INSTALLATION

for Preparation Click here



1. INSTALL VANE PUMP ASSEMBLY


    C106135E01
  1. Install the vane pump assembly with the 2 bolts and the nut.

    Torque:
    Bolt (A):
    48 N*m{ 490 kgf*cm , 35 ft.*lbf }
    Nut (C):
    63 N*m{ 642 kgf*cm , 47 ft.*lbf }

    HINT:
    Turn nut (C) while holding bolt (B).



2. INSTALL VANE PUMP PULLEY


    C106134E01
  1. Using SST, install the vane pump pulley to the vane pump assembly.

    SST
    09960-10010   (09962-01000, 09963-01000)

    Torque:
    43 N*m{ 439 kgf*cm , 32 ft.*lbf }



3. CONNECT PRESSURE FEED TUBE ASSEMBLY
  1. Install a new gasket to the pressure feed tube assembly.



    C106132
  1. Connect the pressure feed tube assembly to the vane pump assembly with the union bolt.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

    HINT:
    Make sure the stopper of the pressure feed tube assembly touches the vane pump assembly.



4. CONNECT OIL RESERVOIR TO PUMP HOSE NO.1


    C106131
  1. Connect the oil reservoir to pump hose No.1 to the vane pump assembly with the clip.



5. INSTALL FAN AND GENERATOR V BELT


    A071310E01
  1. Install the V belt.

  1. Using a bar, adjust the tension of the V-ribbed belt.

  1. Tighten the bolt A and nut B.

    Torque:
    Bolt (A):
    48 N*m{ 489 kgf*cm , 35 ft.*lbf }
    Nut (B):
    64 N*m{ 635 kgf*cm , 47 ft.*lbf }

  1. Check the tension of the V belt. (Click here)



6. ADD POWER STEERING FLUID


7. BLEED POWER STEERING FLUID



8. CHECK FOR POWER STEERING FLUID LEAKS