Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Open in One Side of CAN Sub Bus Line

for Preparation Click here


DESCRIPTION

If "Engine", "ECT (*1)" and "Air Conditioner" do not appear on the intelligent tester's "Communication Bus Check" screen, one side of CAN sub bus line may be open (either CAN-H or CAN-L of the CAN sub bus lines) or the ECM may be defective.

Symptom
Trouble Area
"Engine", "ECT (*1)" and "Air Conditioner" do not appear on the intelligent tester's "Communication Bus Check" screen.
  1. One side of CAN sub bus line is open
  2. CAN J/C
  3. Air conditioning amplifier
  4. ECM

HINT:
*1: Applicable only to automatic transmission vehicles with 2KD-FTV engine.


WIRING DIAGRAM


C107877E01


INSPECTION PROCEDURE

1.CHECK FOR AN OPEN IN ONE SIDE OF THE CAN SUB BUS LINE (AIR CONDITIONING AMPLIFIER SUB BUS LINE)
  1. Turn the ignition switch off.



    G031933E06
  1. Disconnect the air conditioning amplifier sub bus line connector (H3) from the CAN J/C.

    NOTICE:
    1. Before disconnecting the connector, make a note of where it is connected.
    2. Reconnect the connector to its original position.

  1. Turn the ignition switch on.

  1. Select "Communication Bus Check"on the intelligent tester. (Click here )

    Result:
    Go to step
    Result
    A
    "Engine", "ECT (*1)" and "A/C" are not displayed.
    B
    "A/C" is not displayed ("Engine" and "ECT (*1)"are displayed).

    HINT:
    *1: Applicable only to automatic transmission vehicles with 2KD-FTV engine.



B
Go to step 3
A


2.INSPECT CAN J/C
  1. Turn the ignition switch off.

  1. Disconnect the all connectors (H3), (H4) and (H5) from the CAN J/C.

    NOTICE:
    1. Before disconnecting the connectors, make a note of where it is connected.
    2. Reconnect the connectors to its original position.



    G026370E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified value
    CANH - CANL
    IG switch OFF
    108 to 132 Ω



NG
REPLACE CAN J/C
OK

REPLACE ECM 

3.CONNECT CONNECTOR
  1. Reconnect the air conditioning amplifier sub bus line connector (H3) to the CAN J/C.


NEXT


4.CHECK FOR AN OPEN IN ONE SIDE OF THE CAN SUB BUS LINE (AIR CONDITIONING AMPLIFIER SUB BUS LINE)


    C107863E02
  1. Turn the ignition switch off.

  1. Disconnect the air conditioning amplifier connector (H18).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    H18-10 (CANH) -
    H18-11 (CANL)
    IG switch OFF
    54 - 69 Ω



NG
REPAIR OR REPLACE AIR CONDITIONING AMPLIFIER SUB BUS LINE OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER