DRIVE BELT > INSTALLATION |
| 1. INSTALL FAN AND GENERATOR V BELT (w/o Air Conditioning) |
![]() |
Install the V belt.
Using a bar, adjust the tension of the V belt.
Tighten the bolts A and B.
Check the tension of the V belt. (Click here)
| 2. INSTALL FAN AND GENERATOR V BELT (w/ Air Conditioning) |
![]() |
Install the V belt.
Tightening the bolt C, adjust the tension of the V belt.
Tighten the bolts A and B.
Check the tension of the V belt. (Click here)
| 3. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1 (w/ Air Conditioning) |
![]() |
Install the V belt.
Tightening the bolt B, adjust the tension of the V belt.
Tighten nut A.
Check the tension of the V belt. (Click here)
| 4. INSTALL VANE PUMP V BELT |
![]() |
Install the V belt.
Using a bar, adjust the tension of the V-ribbed belt.
Tighten the bolt A and nut B.
Check the tension of the V belt. (Click here)
| 5. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY |
Install the 5 bolts and engine service hole cover.
| 6. INSTALL FRONT DOOR SCUFF PLATE RH |
| 7. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type) |
| 8. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type) |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. PERFORM INITIALIZATION |