Home › ENGINE ยท 5L-E › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL ROD ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on.

  1. Measure the voltage between the terminals (VPA to EPA) of the ECM connector. (Click here)

    Accelerator pedal released:
    0.5 to 1.1 V

    Accelerator pedal depress:
    2.6 to 4.5 V

  1. Measure the voltage between the terminals (VPA2 to E2) of the ECM connector. (Click here)

    Accelerator pedal released:
    1.2 to 2.0 V

    Accelerator pedal depress:
    3.4 to 5.3 V