PRESSURE SWITCH > ON-VEHICLE INSPECTION |
| 1. INSPECT PRESSURE SWITCH (FOR MAGNETIC CLUTCH CONTROL) |
![]() |
Inspect refrigerant pressure in air conditioning cycle.
Read the manifold gauge pressure when these conditions are established.
Test conditions:
![]() |
Check air conditioning operation.
Disconnect the pressure switch connector.
Connect terminals 1 and 4 of the connector of the pressure switch on the vehicle wire harness side using a service wire.
Start the engine.
Turn the air conditioning switch on and check that the magnet clutch is turned on.
Check that the magnet clutch is turned off when disconnecting terminals 1 and 4 (that are connected in the prior step).
| 2. INSPECT PRESSURE SWITCH (FOR COOLING FAN CONTROL) |
Install the manifold gauge.
Disconnect the pressure switch connector and connect terminals 1 and 4 using a tool such as a service wire.
Connect the positive (+) lead from the ohmmeter to terminal 2 and the negative (-) lead to terminal 3.
Start the engine and turn the air conditioning switch on.
![]() |
Check that the continuity between terminals 2 and 3 changes in accordance with the refrigerant pressure as shown in the illustration on the left.