2014-2019 Hiace · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from Jan 2017

HINT:
When replacing the fuel filter element with cap, clean the fuel filter assembly and remove dirt completely.


1. REMOVE STARTER ASSEMBLY
Click here

2. REMOVE FUEL FILTER CAP WITH ELEMENT

  1. A405478E01
    Disconnect the crankshaft position sensor connector and remove the 3 bolts.

  1. Disconnect the 2 connectors.

  1. Detach the 4 clamps and disconnect the engine wire.

  1. A339673E01
    Remove the union bolt and gasket, disconnect the No. 4 fuel pipe sub-assembly from the diesel fuel filter assembly.

  1. A339675E01
    Remove the 2 fuel pipe clamps from the No. 3 fuel pipe and diesel fuel filter assembly.

  1. A339635E01
    Remove the union bolt and gasket, disconnect the No. 3 fuel pipe from the diesel fuel filter assembly.

  1. A339637E01
    Loosen the 4 screws.

  1. A339676E01
    Remove the 2 nuts and disconnect the diesel fuel filter assembly from the cylinder block sub-assembly.

  1. A339637E02
    Remove the 4 screws and fuel filter element from the diesel fuel filter assembly.

    HINT:
    Use a container to catch the draining fuel.

  1. A339638E01
    Remove the O-ring from the diesel fuel filter assembly.


3. INSTALL FUEL FILTER CAP WITH ELEMENT
  1. Clean the diesel fuel filter assembly and remove dirt completely.

  1. Apply a light coat of diesel fuel to a new O-ring.

  1. Install the O-ring to the diesel fuel filter assembly.

  1. Install a new diesel fuel filter element with cap to the fuel filter assembly with the 4 screws.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the diesel fuel filter assembly to the cylinder block sub-assembly with the 2 nuts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Install the No. 3 fuel pipe and a new gasket to the diesel fuel filter assembly with the union bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. A339639E01
    Install the 2 fuel pipe clamps to the diesel fuel filter assembly and No. 3 fuel pipe.

    NOTICE:
    Be careful that the fuel pipe clamp and No. 4 fuel pipe sub-assembly do not interfere with each other.

    HINT:
    Make sure the fuel pipe clamp is oriented as shown in the illustration.

    Text in Illustration 
    *a
    Paint Mark
    *b
    0 to 2 mm (0 to 0.0787 in.)

  1. Install the No. 4 fuel pipe sub-assembly and a new gasket with the union bolt to the diesel fuel filter assembly.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. A405478E02
    Connect the crankshaft position sensor connector.

  1. Attach the 4 clamps and connect the engine wire with the 3 bolts.

    Torque:
    for bolt A:
    8.4 N*m{ 85 kgf*cm , 74 in.*lbf }
    for bolt B:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the 2 connectors.


4. INSTALL STARTER ASSEMBLY
Click here

5. BLEED AIR FROM FUEL SYSTEM
Click here

6. INSPECT FOR FUEL LEAK
Click here
← COMPONENTS (from Jan 2017)COMPONENTS (from Jan 2017) →