REMOVAL
Removal / installation · Vehicles built from Jan 2017
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 3. REMOVE NO. 2 ENGINE UNDER COVER |
Remove the 6 bolts and No. 2 engine under cover.

| 4. REMOVE STARTER ASSEMBLY |
Open the terminal cap.
Remove the nut and disconnect the starter wire.

Disconnect the starter connector.
Remove the 2 bolts, nut, wire harness bracket and starter assembly.

