C1432 Steering Angle Sensor Power Source Voltage Malfunction
Diagnostic trouble codes · Vehicles built from Dec 2017
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
The skid control ECU (brake actuator assembly) outputs this DTC when it receives a sensor power source malfunction signal from the steering angle sensor.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1432 |
Steering angle sensor power supply malfunction signal is received from steering angle sensor. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Do not remove the steering angle sensor from the spiral with sensor cable subassembly.
- When replacing the steering angle sensor (spiral with sensor cable sub-assembly), confirm that the replacement part is of the correct specification.
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- Do not remove the steering angle sensor from the spiral with sensor cable subassembly.
- HINT:
- When U0073, U0124 and/or U0126 is output together with C1432, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first (Click here).
- When the speed sensor or the yaw rate sensor (airbag sensor assembly) has trouble, DTCs for the steering angle sensor (spiral with sensor cable sub-assembly) may be output even when the steering angle sensor is normal. When DTCs for the speed sensor or yaw rate sensor (airbag sensor assembly) are output together with DTCs for the steering angle sensor (spiral with sensor cable sub-assembly), inspect and repair the speed sensor and yaw rate sensor (airbag sensor assembly) first, and then inspect and repair the steering angle sensor (spiral with sensor cable sub-assembly).
- When U0073, U0124 and/or U0126 is output together with C1432, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first (Click here).
| 1. CHECK TERMINAL VOLTAGE (POWER SOURCE CIRCUIT) |
Turn the ignition switch off.
Remove the steering wheel and the column cover.

Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the H92 steering angle sensor (spiral with sensor cable sub-assembly) connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
H92-5 (BAT) - Body ground
Always
11 to 14 V
H92-4 (IG) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Steering Angle Sensor (Spiral with Sensor Cable Sub-assembly))
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (ESS TERMINAL) |
Turn the ignition switch off.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H92-1 (ESS) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Front view of wire harness connector
(to Steering Angle Sensor (Spiral with Sensor Cable Sub-assembly))
- HINT:
- If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
|
|
||||
| OK | ||
| ||
