2014-2019 Hiace · Service Manual BODY ELECTRICAL

Inner Rear View Mirror Power Source Circuit

Circuit diagnosis · Vehicles built from Dec 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2017 from Dec 2017

DESCRIPTION

This is the power source circuit of the inner rear view mirror assembly.

WIRING DIAGRAM

E252798E03

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - BATTERY AND BODY GROUND)

  1. E254244E04
    Disconnect the inner rear view mirror assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    u3-3 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    u3-6 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V

Text in Illustration 
*a
Rear view of wire harness connector
(to Inner Rear View Mirror Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Inner Rear View Mirror Power Source Circuit (Jan 2015 – Nov 2017)COMPONENTS (from Oct 2014) →