Inner Rear View Mirror Power Source Circuit
Circuit diagnosis · Vehicles built Jan 2015 – Nov 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2017 from Dec 2017
DESCRIPTION
This is the power source circuit of the inner rear view mirror assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the inner rear view mirror assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
u3-3 (E) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
u3-6 (IG) - Body ground
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
| *a |
Rear view of wire harness connector (to Inner Rear View Mirror Assembly) |
|
|
||||
| OK | ||
| ||
