INSTALLATION
Removal / installation · Vehicles built from Dec 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
| 1.
TEMPORARILY TIGHTEN FRONT STRUT BAR |
 |
- Measure the length of the A and note it down.
- HINT:
- If using a new strut bar, set the rear side nut to the standard length.
- Install the tube, strut bar cushion, strut bar retainer and washer to the strut bar and temporarily tighten the nut.
- NOTICE:
- Do not place the strut bar retainer and strut bar cushion in the wrong directions.
- Install the strut bar to the front lower ball joint with the 2 bolts and 2 nuts.
-
Torque:
- 90 N*m{
918 kgf*cm
, 66 ft.*lbf
}
Temporally install the strut bar lock nut.
| 2.
INSTALL FRONT WHEEL |
 |
-
Torque:
- 100 N*m{
1,020 kgf*cm
, 74 ft.*lbf
}
| 4.
FULLY TIGHTEN FRONT STRUT BAR |
 |
- Tighten the nut so that the protrusion length of the thread of the front strut bar equals the length of dimension A measured before removal.
- Using SST, fully tighten the strut bar lock nut (rear side).
- SST
- 09326-22011
-
Torque:
- 138 N*m{
1,410 kgf*cm
, 102 ft.*lbf
}
| 5.
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
 |
(Click here)