2014-2019 Hiace · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017


1. TEMPORARILY TIGHTEN FRONT STRUT BAR

  1. C116217E01
    Measure the length of the A and note it down.

    HINT:
    If using a new strut bar, set the rear side nut to the standard length.

  1. C102048E01
    Install the tube, strut bar cushion, strut bar retainer and washer to the strut bar and temporarily tighten the nut.

    NOTICE:
    Do not place the strut bar retainer and strut bar cushion in the wrong directions.

  1. C102011E01
    Install the strut bar to the front lower ball joint with the 2 bolts and 2 nuts.

    Torque:
    90 N*m{ 918 kgf*cm , 66 ft.*lbf }

  1. Temporally install the strut bar lock nut.


2. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }


3. STABILIZE SUSPENSION

4. FULLY TIGHTEN FRONT STRUT BAR

  1. C112994E02
    Tighten the nut so that the protrusion length of the thread of the front strut bar equals the length of dimension A measured before removal.

  1. C106504E01
    Using SST, fully tighten the strut bar lock nut (rear side).
    SST
    09326-22011  

    Torque:
    138 N*m{ 1,410 kgf*cm , 102 ft.*lbf }


5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← REMOVAL (from Oct 2014)INSTALLATION (Jan 2015 – Nov 2015) →