2014-2019 Hiace · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Dec 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017


1. INSTALL FRONT LOWER BALL JOINT
  1. Fix the steering knuckle in the vise using aluminum plates.

    NOTICE:
    Do not damage the steering knuckle.

  1. Install the front lower ball joint to the steering knuckle with the nut.

    Torque:
    170 N*m{ 1,730 kgf*cm , 125 ft.*lbf }

    NOTICE:
    1. Ensure that the thread and taper are free of oil etc.
    2. Do not damage the lower ball joint dust boot.

  1. Install a new cotter pin to the front lower ball joint.

    NOTICE:
    Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.


2. INSTALL FRONT AXLE ASSEMBLY
  1. Temporarily install the front axle assembly to the front suspension upper arm and front suspension lower arm.

  1. C102287E02
    Fully tighten front suspension lower arm with the 4 bolts and 4 nuts.

    Torque:
    Nut (A):
    90 N*m{ 918 kgf*cm , 66 ft.*lbf }
    Nut (B):
    52 N*m{ 530 kgf*cm , 38 ft.*lbf }

  1. C102007E01
    Fully tighten the front suspension upper arm with the nut.

    Torque:
    113 N*m{ 1,147 kgf*cm , 83 ft.*lbf }

    NOTICE:
    Do not damage the lower ball joint dust boot.

  1. Install a new cotter pin to the front suspension upper arm.

    NOTICE:
    Further tighten the castle nut up to 60° if the holes for the cotter pin are not aligned.


3. INSTALL TIE ROD END SUB-ASSEMBLY
  1. Connect the tie rod end sub-assembly LH to the steering knuckle with the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Install a new cotter pin.

    NOTICE:
    Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.


4. INSTALL FRONT DISC BRAKE CYLINDER SUB-ASSEMBLY

5. CONNECT FRONT SPEED SENSOR

  1. C112932E01
    Connect the front speed sensor with the 2 bolts and 2 clips.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    1. Do not twist the sensor wire when installing.
    2. Keep the sensor tip free from foreign matter.


6. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }


7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← INSTALLATION (Jan 2017 – Nov 2017)COMPONENTS (from Oct 2014) →