INSTALLATION
Removal / installation · Vehicles built Jan 2015 – Nov 2015
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
| 1.
INSTALL FRONT LOWER BALL JOINT |
 |
Fix the steering knuckle in the vise using aluminum plates.
- NOTICE:
- Do not damage the steering knuckle.
Install the front lower ball joint to the steering knuckle with the nut.
-
Torque:
- 170 N*m{
1,730 kgf*cm
, 125 ft.*lbf
}
- NOTICE:
- Ensure that the thread and taper are free of oil etc.
- Do not damage the lower ball joint dust boot.
Install a new cotter pin to the front lower ball joint.
- NOTICE:
- Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
| 2.
INSTALL FRONT AXLE ASSEMBLY
|
 |
Temporarily install the front axle assembly to the front suspension upper arm and front suspension lower arm.
- Fully tighten front suspension lower arm with the 4 bolts and 4 nuts.
-
Torque:
- Nut (A):
- 90 N*m{
918 kgf*cm
, 66 ft.*lbf
}
- Nut (B):
- 52 N*m{
530 kgf*cm
, 38 ft.*lbf
}
- Fully tighten the front suspension upper arm with the nut.
-
Torque:
- 113 N*m{
1,147 kgf*cm
, 83 ft.*lbf
}
- NOTICE:
- Do not damage the lower ball joint dust boot.
Install a new cotter pin to the front suspension upper arm.
- NOTICE:
- Further tighten the castle nut up to 60° if the holes for the cotter pin are not aligned.
| 3.
INSTALL TIE ROD END SUB-ASSEMBLY
|
 |
Connect the tie rod end sub-assembly LH to the steering knuckle with the nut.
-
Torque:
- 50 N*m{
510 kgf*cm
, 37 ft.*lbf
}
Install a new cotter pin.
- NOTICE:
- Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
| 4.
INSTALL FRONT DISC BRAKE CYLINDER SUB-ASSEMBLY |
|
| 5.
CONNECT FRONT SPEED SENSOR
|
 |
- Connect the front speed sensor with the 2 bolts and 2 clips.
-
Torque:
- 8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
- NOTICE:
- Do not twist the sensor wire when installing.
- Keep the sensor tip free from foreign matter.
| 6.
INSTALL FRONT WHEEL |
 |
-
Torque:
- 100 N*m{
1,020 kgf*cm
, 74 ft.*lbf
}
| 7.
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
 |
(Click here)