2014-2019 Hiace · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL GENERATOR DRIVE END FRAME BEARING

  1. A102672
    Using SST and a press, press in a new bearing.
    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)

  1. A079311E01
    Align the claws of the bearing retainer with the grooves inside the drive end frame.

  1. Install the bearing retainer with the 4 screws.


2. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Install the rotor and washer to the drive end frame.


3. INSTALL GENERATOR COIL ASSEMBLY

  1. A102673E01
    Using deep socket wrench (21 mm) and a press, slowly press in the generator coil assembly.

  1. A079304
    Install the generator coil assembly with the 4 through bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }


4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

  1. A113845E01
    While pushing the 2 brushes to the inside of the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the generator brush holder hole.

  1. A079303E01
    Install the brush holder assembly with the 2 screws.

  1. Pull out the pin from the brush holder assembly.


5. INSTALL TERMINAL INSULATOR

  1. A079318
    Install the terminal insulator.


6. INSTALL GENERATOR REAR END COVER

  1. A079302
    Install the generator rear end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


7. INSTALL GENERATOR WITH CLUTCH PULLEY
  1. Install the pulley by hand.

  1. A115866E01
    Install SST to the pulley and vise as shown in the illustration.
    SST
    09820-63020  

  1. A113786E01
    Turn SST (B) counterclockwise, and tighten the pulley.
    SST
    09820-63020  

    Torque:
    87 N*m{ 891 kgf*cm , 64 ft.*lbf }

    NOTICE:
    Use a torque wrench with a fulcrum length of 380 mm (14.96 in.).

  1. Check that the generator pulley rotates smoothly.

  1. Install the generator pulley cap.

← INSPECTION (from Oct 2014)INSTALLATION (Oct 2014 – Mar 2016) →