2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT GENERATOR WITH CLUTCH PULLEY

  1. A115864E01
    When rotating the pulley, check that it turns counterclockwise and it does not turn clockwise.


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A113754E01
    Using vernier calipers, measure the brush length.

    Standard length:
    10.5 mm (0.413 in.)

    Minimum length:
    4.5 mm (0.177 in.)

    If the length is less than the minimum, replace the brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A079306
    Inspect that the bearing is not rough or worn.
    If necessary, replace the rotor.

  1. B012264E01
    Check the rotor for open circuit.

    1. Using an ohmmeter, measure the resistance between the slip rings.

      Standard resistance:
      2.3 to 2.7 Ω at 20°C (68°F)

      If the resistance is not within the standard range, replace the rotor.

  1. B012265E01
    Check the rotor for ground.

    1. Using an ohmmeter, check that there is no continuity between the slip ring and rotor.
      If there is continuity, replace the rotor.

  1. B012266
    Using vernier calipers, measure the slip ring diameter.

    Standard diameter:
    14.2 to 14.4 mm (0.559 to 0.567 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    If the diameter is less than the minimum, replace the rotor.

← DISASSEMBLY (from Oct 2014)REASSEMBLY (from Oct 2014) →