DISASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1. REMOVE STARTER YOKE ASSEMBLY |
Remove the nut and disconnect the lead wire from terminal C.

Remove the 2 bolts.

Pull out the starter yoke with the armature.
Remove the O-ring from the starter yoke assembly.
| 2. REMOVE MAGNET STARTER SWITCH ASSEMBLY |
Remove the 2 screws and magnet starter switch.

Remove the return spring, pinion gear, idler gear, clutch roller, retainer and starter clutch from the starter housing.


Using a magnetic finger, remove the steel ball from the clutch shaft hole.

| 3. REMOVE STARTER BRUSH HOLDER ASSEMBLY |
![]() ![]() |
Disconnect the 4 starter yoke brushes from the brush holder.
Using a screwdriver, pull back the spring.
Disconnect the brush from the brush holder.
Remove the brush holder assembly from the starter yoke assembly.
| 4. REMOVE STARTER ARMATURE ASSEMBLY |
![]() ![]() |
Using a plastic-faced hammer, tap the frame end to remove the starter armature assembly from the starter yoke assembly.


