2014-2019 Hiace · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2017


1. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A341308
    Remove the nut and disconnect the lead wire from terminal C.

  1. A341309
    Remove the 2 nuts from the repair service starter kit while holding the magnet starter switch assembly.

  1. A341310
    Pull the magnet starter switch assembly and, while lifting the front part of the magnet starter switch assembly, release the plunger hook from the starter pinion drive lever and remove the magnet starter switch assembly.


2. REMOVE STARTER YOKE ASSEMBLY

  1. A341311
    Using a T25 "TORX" socket wrench, remove the 2 bolts.

  1. A341312
    Remove the starter yoke assembly and starter commutator end frame assembly from the repair service starter kit.

  1. A341314
    Remove the starter armature plate from the starter yoke assembly or repair service starter kit.

  1. A341315
    Remove the 3 planetary gears from the repair service starter kit.

  1. A356494
    Remove the rubber seal from the repair service starter kit.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A341313
    Remove the 2 screws from the starter commutator end frame assembly.

  1. A377034
    Remove the starter commutator end frame assembly from the starter yoke assembly.

    NOTICE:
    While holding down the lead wire, remove the starter commutator end frame assembly.

  1. A368709
    Remove the starter brush holder assembly from the starter armature assembly.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A202438
    Remove the starter armature assembly from the starter yoke assembly.

← REMOVAL (from Jan 2017)INSPECTION (from Jan 2017) →