2014-2019 Hiace · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL STARTER CLUTCH ASSEMBLY
  1. Apply grease to the steel ball, return spring, clutch roller, retainer, pinion gear and idler gear.

  1. P005018E01
    Install the steel ball.

  1. Insert the return spring into the starter clutch hole.

  1. Install the starter clutch, idler gear, pinion gear, retainer and clutch roller.

    A121405E02

  1. S004230E01
    Install the starter housing to the magnet switch with the 2 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


2. INSTALL STARTER ARMATURE ASSEMBLY
  1. Apply grease to the starter armature bearing.

  1. P004699E01
    Using a press, press the starter armature into the starter yoke assembly.


3. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. ST00096E02
    Align the claw of the brush holder with the claw groove of the starter yoke assembly.

  1. Place the brush holder on the starter yoke assembly.

  1. N000562E01
    Install the 4 starter yoke brushes to the brush holder.

    1. Using a screwdriver, pull back the spring.

    2. Install the brush to the brush holder.

      NOTICE:
      Check that the positive (+) lead wires are not grounded.


4. INSTALL STARTER YOKE ASSEMBLY

  1. ST00100E01
    Install a new O-ring to the groove of the starter yoke assembly.

  1. P005017E01
    Align the claws of the starter brush holder with the grooves of the magnet starter switch, and install the starter yoke assembly and starter armature assembly.

  1. Align the punch mark of the starter yoke with the line of the magnet starter switch assembly.

  1. S004229E03
    Install 2 new O-rings to the bolts.

  1. Install the starter yoke with the 2 bolts.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. P013020E01
    Connect the lead wire to terminal C with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Oct 2014)INSTALLATION (Oct 2014 – Dec 2014) →