2014-2019 Hiace · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


1. REMOVE GENERATOR PULLEY CAP

  1. A223934
    Using a screwdriver, remove the generator pulley cap.


2. REMOVE GENERATOR WITH CLUTCH PULLEY
  1. Mount the generator assembly in a vise between aluminum plates.

  1. A219550E01
    Install SST (A) and SST (B) to the generator with clutch pulley as shown in the illustration.
    SST
    09820-63021  
    Text in Illustration 
    *1
    Generator Rotor Shaft

    NOTICE:
    Securely attach SST to the generator with clutch pulley and generator rotor shaft.

  1. A219551E01
    Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator with clutch pulley.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    NOTICE:
    Be careful as the generator with clutch pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

  1. Remove SST from the generator assembly.

  1. Remove the generator with clutch pulley from the rotor shaft.


3. REMOVE GENERATOR REAR END COVER

  1. A220454
    Remove the 3 nuts and generator rear end cover.


4. REMOVE TERMINAL INSULATOR

  1. A230103
    Remove the terminal insulator.


5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A230104
    Remove the 2 screws and generator brush holder assembly.


6. REMOVE GENERATOR COIL ASSEMBLY

  1. A230105
    Remove the 4 through bolts.

  1. A115868E02
    Using SST, remove the generator coil assembly.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
    Text in Illustration 
    *a
    Hold
    V100135
    Turn


7. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A118365
    Remove the generator washer.

  1. A224329
    Remove the generator rotor assembly from the generator drive end frame assembly.


8. INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A102579
    Check that the generator drive end frame bearing is not rough or worn.
    If necessary, replace the generator drive end frame bearing.


9. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A230106
    Remove the 4 screws and retainer plate.

  1. A102581E01
    Using SST and a hammer, tap out the generator drive end frame bearing.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← REMOVAL (from Apr 2016)DISASSEMBLY (from Jan 2015) →