2014-2019 Hiace · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


1. REMOVE GENERATOR PULLEY CAP

  1. A339215
    Using a screwdriver, puncture the center of the generator pulley cap and pry it off.

    NOTICE:
    Do not reuse the generator pulley cap.


2. REMOVE GENERATOR PULLEY WITH CLUTCH
  1. Mount the generator assembly in a vise between aluminum plates.

  1. A339216E01
    Install SST A and SST B to the generator pulley with clutch as shown in the illustration.
    SST
    09820-63021  
    Text in Illustration 
    *a
    Generator Rotor Shaft

    NOTICE:
    Securely attach SST to the generator pulley with clutch and generator rotor shaft.

  1. A339218E01
    Using a wrench to hold SST A, turn SST B counterclockwise to loosen the generator pulley with clutch.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    NOTICE:
    Be careful as the generator pulley with clutch or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

  1. Remove SST from the generator assembly.

  1. Remove the generator pulley with clutch from the generator rotor shaft.

  1. Remove the generator assembly from the vise.


3. REMOVE GENERATOR REAR END COVER

  1. A339219
    Place the generator assembly on the generator pulley with clutch.

  1. A339220
    Remove the 3 bolts and generator rear end cover from the generator coil assembly.


4. REMOVE GENERATOR TERMINAL INSULATOR

  1. A339221
    Remove the generator terminal insulator from the generator coil assembly.


5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A339222
    Remove the 2 screws and generator brush holder assembly from the generator coil assembly.


6. REMOVE GENERATOR COIL ASSEMBLY

  1. A339223
    Remove the 4 bolts.

  1. A339224E01
    Using SST, remove the generator coil assembly.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
    Text in Illustration 
    *a
    Hold
    V100135
    Turn


7. REMOVE GENERATOR BEARING COVER PACKING

  1. A284548
    Remove the generator bearing cover packing.

    NOTICE:
    If the generator bearing cover packing breaks, remove all broken pieces.

    HINT:
    The generator bearing cover packing may be installed on the generator rotor assembly.


8. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A339225
    Remove the generator rotor assembly.


9. INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A339228
    Check that the generator drive end frame bearing is not rough or worn and that it rotates smoothly.
    If necessary, replace the generator drive end frame bearing.


10. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A339226
    Remove the 4 screws and retainer plate from the generator drive end frame.

  1. A339227E01
    Using SST and a hammer, tap out the generator drive end frame bearing from the generator drive end frame.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← DISASSEMBLY (Oct 2014 – Dec 2014)INSPECTION (Oct 2014 – Dec 2014) →