2014-2019 Hiace · Service Manual DRIVE LINE

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. REMOVE UNIVERSAL JOINT SPIDER ASSEMBLY

  1. C115683E01
    Put matchmarks on the flange yoke and propeller shaft assembly.

  1. C061264
    Using a brass bar and a hammer, slightly tap in the spider bearing outer races.

  1. Using 2 screwdrivers, remove the 4 snap rings from the grooves.

  1. Hold the propeller shaft assembly in a vise between aluminium plates.

    NOTICE:
    Do not overtighten the vise.

  1. C115684E01
    Using SST, push out the spider bearing from the propeller shaft.
    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.

  1. C115685E01
    Clamp the spider bearing outer race in a vise between aluminium plates and tap off the propeller shaft with a hammer.

    NOTICE:
    1. Do not overtighten the vise.
    2. Do not tap the shaft.

    HINT:
    Remove the spider bearing on the opposite side using the same procedure.

  1. Install the 2 removed spider bearing outer races to the spider.

  1. Hold the flange yoke in a vise between aluminium plates.

    NOTICE:
    Do not overtighten the vise.

  1. C115686E01
    Using SST, push out the spider bearing from the flange yoke.
    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.

  1. C115687E01
    Clamp the spider bearing outer race in a vise between aluminium plates and tap off the propeller shaft with a hammer.

    NOTICE:
    1. Do not overtighten the vise.
    2. Do not damage the flange yoke.

  1. Remove the universal joint spider.

    HINT:
    Remove the spider bearing on the opposite side using the same procedure.

← REMOVAL (from Oct 2014)REASSEMBLY (Oct 2014 – Nov 2017) →