2014-2019 Hiace · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

  1. C112188E01
    Install the 2 rear shock absorber bushings on the rear shock absorber.

    NOTICE:
    Be careful of size differences between the upper and lower rear shock absorber bushings.

    HINT:
    If the rear shock absorber bushing is separated, install it as shown in the illustration.

  1. C103907E01
    Install the cushion washer No.2.

  1. Temporarily tighten the upper side of the rear shock absorber assembly with the bolt.

  1. C103908E01
    Install the cushion washer No.4.

  1. Temporarily tighten the lower side of the rear shock absorber assembly with the bolt.


2. STABILIZE SUSPENSION
  1. After lowering the vehicle, bounce the vehicle up and down to stabilize the rear suspension.


3. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

  1. C101411
    Fully tighten the bolt on the upper side.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }

  1. C101410
    Fully tighten the bolt on the lower side.

    Torque:
    43 N*m{ 440 kgf*cm , 32 ft.*lbf }

← INSPECTION (from Oct 2014)DISPOSAL (from Oct 2014) →