1.
INSTALL INNER KNUCKLE GREASE RETAINER CAP (w/ Cap)
Using SST, place the steering knuckle on a press as shown in the illustration.
SST
09527-30010
Temporarily install a new inner knuckle grease retainer cap to the steering knuckle as shown in the illustration.
NOTICE:
Align the center of the cutout in the inner knuckle grease retainer cap and the groove of the steering knuckle.
Using SST and the press, press the inner knuckle grease retainer cap into the steering knuckle until the distance (A) in the illustration meets the standard value.
SST
09950-70010
(09951-07100)
09951-00900
Distance (A):
26 +/- 0.5 mm (1.02 +/- 0.0196 in.)
NOTICE:
Using a vernier caliper, measure the distance (A) at the 3 points indicated by the arrows in the illustration while pressing.
2.
INSTALL FRONT LOWER BALL JOINT ASSEMBLY
Fix the steering knuckle in the vise using aluminium plates.
NOTICE:
Do not damage the steering knuckle.
Install the front lower ball joint assembly to the steering knuckle with the nut.
Torque:
170 N*m{
1,730 kgf*cm
, 125 ft.*lbf
}
NOTICE:
Ensure that the thread and taper are free of oil etc.
Do not damage the lower ball joint dust boot.
Install a new cotter pin to the front lower ball joint assembly.
NOTICE:
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
3.
INSTALL STEERING KNUCKLE
Install the steering knuckle and brake dust cover to the front axle hub sub-assembly with the 4 bolts.
Torque:
88 N*m{
897 kgf*cm
, 65 ft.*lbf
}
4.
INSTALL OUTER KNUCKLE GREASE RETAINER CAP (w/ Cap)
Using SST, install a new outer knuckle grease retainer cap.