2014-2019 Hiace · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Oct 2014 – Mar 2016

Versions by build date: Oct 2014 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

  1. C102640E03
    Install the lock nut to the push rod.
    Text in Illustration 
    *1
    Push Rod Clevis
    *2
    Push Rod
    *3
    Lock Nut

  1. Install the push rod clevis and temporarily tighten the lock nut.

    HINT:
    1. Be sure to install the lock nut at the same position as before removal.
    2. Fully tighten the lock nut when adjusting the clutch pedal.


2. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

  1. C102638
    Install the clutch master cylinder with the 2 nuts.

    Torque:
    14 N*m{ 145 kgf*cm , 10 ft.*lbf }

  1. C102635E04
    Apply MP grease to the sliding portions of the push rod clevis and clutch pedal.
    Text in Illustration 
    V100135
    MP grease

  1. Install the push rod clevis to the cutout of the pedal from the right side of the vehicle and push it downward.

    NOTICE:
    Check that the push rod cannot be turned 30° or more in order to confirm that the clevis is securely engaged in the pedal.

  1. C102639E02
    Using a union nut wrench, connect the clutch tube to the clutch master cylinder.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    Text in Illustration 
    *a
    Yellow Mark

    NOTICE:
    Use the formula to calculate special torque value for situations where a union nut wrench is combined with a torque wrench (Click here).

  1. Connect the clutch reservoir tube with the clip.

    NOTICE:
    Face the yellow mark upward.


3. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (for LHD)
  1. w/ Rear Wiper:
    Connect the 2 connectors and 2 washer hoses.

  1. w/o Rear Wiper:
    Connect the connector and washer hose.

  1. Attach the washer hose to the windshield washer motor and pump assembly.

  1. Install the windshield washer motor and pump assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the connector to the windshield washer motor and pump assembly.


4. ADD BRAKE FLUID

Fluid:
SAE J1703 or FMVSS No. 116 DOT3 or equivalent


5. BLEED CLUTCH LINE
  1. Fill the brake reservoir tank with brake fluid and bleed the clutch system.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }


6. CHECK FOR BRAKE FLUID LEAKAGE

HINT:
Check for leakage in the clutch system.


7. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
  1. Check the fluid level and add fluid if necessary.

    Fluid:
    SAE J1703 or FMVSS No.116 DOT3 or equivalent


8. INSPECT AND ADJUST CLUTCH PEDAL HEIGHT
(Click here)
← REMOVAL (from Oct 2014)INSTALLATION (Apr 2016 – Dec 2016) →