REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1. DRAIN BRAKE FLUID |
- NOTICE:
- Wash brake fluid off immediately if it spills on any painted surface.
| 2. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (for LHD) |
Remove the 2 bolts and windshield washer motor and pump assembly.
| 3. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY |
Slide the clip and separate the clutch reservoir tube.

- HINT:
- Use a container to catch the fluid.
Using a union nut wrench, disconnect the clutch tube from the clutch master cylinder.
- HINT:
- Use a container to catch the fluid.
Push the push rod clevis upward and release it toward the right side of the vehicle.

Remove the 2 nuts and clutch master cylinder.

| 4. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS |
Loosen the lock nut and remove the push rod clevis.

Remove the lock nut.
- HINT:
- Measure dimension A shown in the illustration so that the measurement can be used as a reference when installing the push rod clevis.
