Coat a new O-ring with ATF, and install it to the oil filler tube.
Install the oil filler tube to the automatic transmission with the 2 bolts.
Torque:
12 N*m{
122 kgf*cm
, 9 ft.*lbf
}
6.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7.
ADD AUTOMATIC TRANSMISSION FLUID
8.
INSPECT AUTOMATIC TRANSMISSION FLUID
HINT:
Drive the vehicle so that the engine and transmission are at normal operating temperature.
Fluid temperature:
70 to 80 °C (158 to 176 °F)
Park the vehicle on a level surface and set the parking brake.
With the engine idling and the brake pedal depressed, move shift the lever into all positions from P to L and return to the P position.
Take out the dipstick and wipe it clean.
Put it back all the way.
Take it out again and check that the fluid level is within the HOT range. If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.