2014-2019 Hiace · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL REAR SPRING SHACKLE UPPER BUSHING

  1. C102267E01
    Install the 2 rear spring shackle upper bushings and collar.


2. TEMPORARILY TIGHTEN REAR LEAF SPRING ASSEMBLY

  1. C101416E01
    Install the rear leaf spring assembly to the body and temporarily tighten a new bolt and a new nut.

  1. Install the rear leaf spring assembly, shackle plate, and spring shackle, and temporarily tighten 2 new bolts and a new nut.

    C112187E01

  1. Install the leaf spring dynamic damper with the bolt. (w/ dynamic damper type)


3. TEMPORARILY TIGHTEN SPRING U-BOLT SEAT SUB-ASSEMBLY

  1. C101418
    Install the spring U-bolt seat sub-assembly and temporarily tighten 2 new rear spring U-bolts, 4 new nuts and 4 washers.

    NOTICE:
    Align the leaf spring center bolt and nut with the installation hole of the rear axle housing and spring U-bolt seat sub-assembly so that they are not loose.


4. CONNECT REAR SHOCK ABSORBER ASSEMBLY

  1. C103912E01
    Install the cushion washer No.4.

  1. Temporarily tighten the rear shock absorber assembly with the bolt.


5. CONNECT CABLE SUPPORT BRACKET NO.3

  1. C102264
    Connect the cable support bracket No.3 with the 2 bolts.

    Torque:
    14.5 N*m{ 148 kgf*cm , 11 ft.*lbf }


6. INSTALL REAR WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }


7. INSTALL SPARE TIRE

8. STABILIZE SUSPENSION
  1. After lowering the vehicle, bounce the vehicle up and down to stabilize the rear suspension.


9. FULLY TIGHTEN REAR LEAF SPRING ASSEMBLY

  1. C101416E01
    Fully tighten the bolt.

    Torque:
    95 N*m{ 970 kgf*cm , 70 ft.*lbf }

  1. C101415E01
    Fully tighten the bolts (A) and (B).

    Torque:
    95 N*m{ 970 kgf*cm , 70 ft.*lbf }

  1. Fully tighten the bolt (C). (w/ dynamic damper type)

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }


10. FULLY TIGHTEN SPRING U-BOLT SEAT SUB-ASSEMBLY

  1. C103911
    Fully tighten the 4 nuts.

    Torque:
    95 N*m{ 970 kgf*cm , 70 ft.*lbf }

    NOTICE:
    1. Tighten the nuts evenly.
    2. The amount of tightening for each of the 4 nuts must be the same.


11. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

  1. C101410
    Fully tighten the bolt.

    Torque:
    43 N*m{ 440 kgf*cm , 32 ft.*lbf }

← REASSEMBLY (from Oct 2014)COMPONENTS (from Oct 2014) →