REASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1. INSTALL REAR SPRING LEAF BUSHING |
Install a new bushing to the leaf spring.

Install the bushing, aligning with the matchmarks so that the openings are facing as shown in the illustration.
- NOTICE:
- Be sure to install each bushing to the correct positions.
Use the SST and press, press both bushings into the leaf spring.
- SST
- 09223-00010
09632-36010
- NOTICE:
- Align the SST, which presses the bushing, to the outer casing of the bushing.
| 2. INSTALL REAR SPRING SILENCER |
Install the 2 rear spring silencers with the 2 nuts.

- Torque:
- 38 N*m{ 388 kgf*cm , 28 ft.*lbf }
| 3. INSTALL REAR SPRING SILENCER NO.1 |
| 4. REASSEMBLY REAR LEAF SPRING ASSEMBLY |
Install the spacer on the leaf spring.
Secure the leaf spring in a vise using aluminum plates. Temporarily install the center bolt and nut.
Use a vise with aluminum plates to cramp the spring clip.

Hold the center bolt with pliers and tighten the nut.

- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
| 5. INSTALL LEAF SPRING DYNAMIC DAMPER (FOR VAN WITH DYNAMIC DAMPER) |
Install the leaf spring dynamic damper with the bolt as shown in the illustration.

- Torque:
- 18 N*m{ 184 kgf*cm , 13 ft.*lbf }
| 6. INSTALL REAR SPRING CLIP BOLT CASE (FOR VAN WITHOUT DYNAMIC DAMPER) |
Install the rear spring clip bolt case with the bolt as shown in the illustration.

- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
| 7. INSTALL LEAF SPRING DYNAMIC DAMPER ASSEMBLY (FOR COMMUTER WITH DYNAMIC DAMPER) |
Install the leaf spring dynamic damper assembly with the 2 nuts.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
| 8. INSTALL REAR LEAF SPRING DYNAMIC DAMPER BRACKET (FOR COMMUTER WITHOUT DYNAMIC DAMPER) |
Install the rear leaf spring dynamic damper bracket with the 2 nuts.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
