REMOVAL
Removal / installation · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2016 from Jan 2017
| 1.
REMOVE BATTERY SERVICE HOLE COVER |
|
| 2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 3.
REMOVE FRONT DOOR SCUFF PLATE RH |
|
| 4.
REMOVE FRONT SEAT ASSEMBLY RH |
 |
- for Hi-back Seat Type (Click here)
- for Low-back Seat Type (Click here)
- for Split Bench Seat Type (Click here)
| 5.
REMOVE ECM |
 |
Fold back the floor carpet.
- Remove the 3 bolts and disconnect the ECM.
- Detach the 2 wire harness clamps from the No. 1 ECM bracket and No. 2 ECM bracket.
Text in Illustration
*a
|
Push
|
*b
|
Lock
|
Disconnect the 2 ECM connectors and remove the ECM.
- NOTICE:
- After disconnecting a ECM connector, make sure that dirt, water and other foreign matter does not contact the ECM connector.
Raise the 2 levers while pushing the locks on the 2 levers and disconnect the 2 ECM connectors.
Remove the ECM.
| 6.
REMOVE NO. 1 ECM BRACKET |
 |
- Remove the 3 screws and No. 1 ECM bracket.
| 7.
REMOVE NO. 2 ECM BRACKET |
 |
- Remove the 2 screws and No. 2 ECM bracket.