2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

2. SEPARATE VANE PUMP OIL RESERVOIR ASSEMBLY

  1. C101999E01
    Remove the 2 bolts and vane pump oil reservoir assembly.

    NOTICE:
    Suspend the vane pump oil reservoir assembly with wire to prevent power steering fluid from spilling out.


3. DISCONNECT OIL RETURN HOSE (w/ Intercooler)
  1. Disconnect the oil return hose from the intake manifold.


4. REMOVE EGR PIPE SUB-ASSEMBLY NO.1

  1. A106043
    Disconnect the fuel pressure sensor connector.

  1. A106844
    Remove the 2 bolts, 2 nuts, and the EGR pipe sub-assembly.

  1. Remove the 2 gaskets.


5. REMOVE AIR HOSE NO.4
  1. Remove the clamp, and disconnect the air hose No.4 from the diesel throttle body.


6. REMOVE DIESEL THROTTLE BODY ASSEMBLY

  1. A102282
    Disconnect the 2 throttle body connectors.

  1. A102902
    Remove the 2 bolts, 2 nuts, and the diesel throttle body assembly.

  1. Remove the gasket from intake air connector.


7. REMOVE ENGINE SERVICE HOLE COVER NO.2

  1. A113043
    Roll up the carpet.

  1. Remove the 3 bolts and the engine service hole cover No.2.


8. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY

  1. Remove the vacuum regulating valve.

    1. A103046
      Remove the 2 vacuum hoses and the vacuum regulating valve connector.

    2. Remove the 2 bolts and the vacuum regulating valve.

  1. Remove the EGR valve assembly with the sensor.

    1. A115757
      Remove the bolt, and separate the manifold stay.

    2. Disconnect the vacuum hose from the intake air connector.

    3. A103043
      Disconnect the intake air temperature sensor connector.

    4. Disconnect the EGR valve position sensor connector.

    5. A115761E01
      Remove the bolt, 2 nuts and the intake air connector assembly.

    6. Remove the 2 gaskets and EGR valve assembly from the intake air connector.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →