2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT ELECTRIC EGR CONTROL VALVE ASSEMBLY

  1. Inspect the vacuum regulating valve.

    1. A103042E01
      Check that there is continuity between the terminals.

      Standard resistance:
      11 to 13 Ω (20°C)

    2. Apply battery voltage across the terminals, and check that air flows from each port.

      Standard:
      Measuring Condition
      Measuring Port
      Airflow
      No continuity
      E←→Ventilation port
      Airflows
      No continuity
      Ventilation port←→F
      E←→F
      Air does not flows
      Continuity
      E←→F
      Airflows
      Continuity
      Ventilation port←→E
      Ventilation port←→F
      Air does not flows

  1. Inspect the EGR valve.

    1. A099571
      When a vacuum of 26.7 kPa (200 mmHg, 7.87 in.Hg) is applied to the diaphragm chamber, check that the shaft rises and that air flows out.

    2. Maintaining the above conditions, check again that there are no leaks and that the shaft does not lower.

    3. Check that the valve is not stuck and does not have heavy carbon deposits.
      If the result is not as specified, replace the EGR valve.

  1. Inspect the EGR valve position sensor.

    1. A085764E01
      Using an ohmmeter, measure the resistance between terminals 1 (VC) and 2 (E2) of the EGR valve position sensor.

      Standard resistance:
      4.0 to 6.0 kΩ at 20°C (68°F)

      If the result is not as specified, replace the EGR valve.

    2. A099572E01
      Create a vacuum in the diaphragm chamber. Measure the resistance between terminals 3 (EGLS) and (E2) of the lift sensor when the valve is fully opened and fully closed.

      Standard resistance:
      EGR Valve Condition
      Specified Condition
      Fully opened
      2.0 to 7.0 kΩ at 20°C (68°F)
      Fully closed
      0.1 to 2.5 kΩ at 20°C (68°F)

      HINT:
      The resistance increases in proportion to the opening angle of the EGR valve.

      If the result is not as specified, replace the EGR valve.

← REMOVAL (from Oct 2014)INSTALLATION (from Oct 2014) →