REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1. DISCONNECT BATTERY NEGATIVE CABLE |
| 2. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY |
Remove the transmission oil level gauge from the transmission oil filler tube.

| 3. DRAIN AUTOMATIC TRANSMISSION FLUID |
Remove the drain plug and gasket and drain the automatic transmission fluid.

Install the drain plug with a new gasket.
- Torque:
- 20 N*m{ 205 kgf*cm , 15 ft.*lbf }
| 4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
Remove the oil filler tube with 2 bolts.

Remove the O-ring from the oil filler tube.
| 5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
Uniformly loosen the 19 bolts and remove the transmission oil pan sub-assembly.

Using oil pan seal cutter, remove the transmission oil pan.

- NOTICE:
- Be careful not to damage the oil pan and flange.
- Do not incline the oil pan because of any fluid will remain in the oil pan.
- Be careful not to damage the oil pan and flange.
Remove the 3 magnets from the transmission oil pan.

| 6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY |
Remove the oil strainer assembly and 3 gaskets with 4 bolts.

| 7. SEPARATE TRANSMISSION WIRE |
Disconnect the temperature sensor and 4 transmission solenoid connectors from the transmission valve body.

| 8. REMOVE TRANSMISSION WIRE |
Disconnect the transmission wire connector.

Remove the bolt and pull out the transmission wire.
Remove the O-ring from the transmission wire.

