2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017


1. INSTALL REAR CRANKSHAFT OIL SEAL
  1. Apply MP grease to a new rear crankshaft oil seal lip.

    NOTICE:
    Keep the lip free from foreign matter.

  1. A102145E02
    Using SST and a hammer, tap in the rear crankshaft oil seal until its surface is flush with the rear oil seal retainer edge.
    SST
    09223-15030  
    09950-70010   (09951-07150)

    NOTICE:
    Wipe off extra grease from the crankshaft.


2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

  1. G038107E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A314019E01
    Install the front drive plate spacer, drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.
    Text in Illustration 
    *1
    Front Drive Plate Spacer (Reversible)
    *2
    Drive Plate and Ring Gear Sub-assembly
    *3
    Rear Drive Plate Spacer
    V100135
    Transmission Side
    V100136
    Engine Side

    HINT:
    1. The front drive plate spacer is reversible.
    2. As the rear drive plate spacer and drive plate and ring gear sub-assembly are not reversible, be sure to install it so that it is facing in the direction shown in the illustration.

  1. Clean the bolts and bolt holes.

  1. Apply adhesive to 2 or 3 threads at the end of each of the 10 bolts.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. A222355E01
    Install and uniformly tighten the 10 bolts in several steps in the sequence shown in the illustration.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    NOTICE:
    Do not start the engine for at least an hour after installing the drive plate and ring gear sub-assembly.


3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)
← REMOVAL (from Jan 2017)INSTALLATION (Jan 2015 – Dec 2016) →