2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

2. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side. (Click here)


3. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side. (Click here)


4. REMOVE FRONT DOOR SCUFF PLATE RH

5. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the engine service hole sub cover assembly.


6. SEPARATE OIL COOLER OUTLET TUBE SUB-ASSEMBLY NO. 2 (for Automatic Transmission)

  1. A269525
    Remove the 2 bolts and oil cooler outlet tube sub-assembly No. 2.


7. REMOVE FAN & GENERATOR V BELT

  1. A102808E03
    Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.


8. REMOVE CRANKSHAFT PULLEY

  1. A269522
    Disconnect the oil pressure switching valve connector.

  1. A269523E01
    Remove the bolt holding the crankshaft with SST.
    SST
    09213-58013  
    09330-00021  

  1. Insert the service bolt.

  1. A072414E01
    Remove the crankshaft pulley with SST.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply grease to the thread and tip of the SST (Center bolt) before use.


9. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

  1. A072415E01
    Remove the oil seal with SST.
    SST
    09308-10010  
    09950-50013   (09957-04010)
    09950-60010   (09951-00350)

    NOTICE:
    Make sure that there is no damage such as scratch on the inner joint face of the crankshaft after the oil seal removal. If it is found, make the surface smooth by a sandpaper (#400).

← COMPONENTS (from Oct 2014)INSTALLATION (from Oct 2014) →